Comprehensive Parts List for:

Camera Ribbon Cable

The following list is provided to identify all of the parts that will be involved in the process of removing and replacing the Camera Ribbon Cable. Replacing these parts with new parts is not required unless it is determined that a part is not suitable for reuse. VideoRay recommends that new O-rings be used whenever possible.

FB-001-KIT-P4 Float Block Kit

SK-PRO4-KIT Skid Kit

GTO-006L-KIT~GTO-006R-KIT Horizontal Thruster Propeller Kit (Left and Right)

VR-PRO4-08-0001 Horizontal Thruster Nozzle Kit

MHU-002-GY-KIT Dome Retaining Rings and Main Hull Rods

MHU-004(f) Front Dome

VR-PRO4-13-0001-N Front Hull Ring Assembly with Camera

MHU-004(r) Rear Dome

MHU-003-GY-KIT Rear Hull Ring Assembly

TLK-005-300-CN Desiccant Pack

CB-01-PRO4-SET ROV Board Set

HF12U-10-ND Camera Ribbon Cable

This list includes quantities for both sides where applicable. With the exception of the horizontal thruster propellers, parts can be interchanged between left (port) and right (starboard) sides.