Horizontal Thruster Motor Mount Replacement Procedures

Time required for this step: Approximately 5 Minutes (10 Minutes for both sides)

Tools required for this step:

• #2 Phillips Head Screw Driver

Parts involved in this step:

MAR-004 Horizontal Thruster Motor Mount

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you are replacing both Horizontal Motor Mounts.

1. Orient the horizontal motor mount so that the open end is facing toward the shaft end of the horizontal thruster motor assembly.

2. Slide the horizontal motor mount over the horizontal thruster motor shaft and onto the horizontal thruster motor assembly.

3. Align the screw holes of the horizontal motor mount and horizontal motor assembly. Note the hole pattern is diamond shaped, not square.

4. Replace the screws through the motor mount into the motor and tighten the screws.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view