Camera Tilt Servo Motor Assembly Removal Procedures

Time required for this step: Approximately 5 Minutes

Tools required for this step:

#1 Phillips Head Screw Driver

Parts involved in this step:

MAR-012 Camera Tilt Servo Motor Assembly

Quantity	Part Number	Part Description
1	MAR-012	Camera Package Tilt Servo (Pro 4)
2	91772A106	Screw #4-40 x 1/4" Pan Head Phillips SS
2	98017A610	Washer #4 x 0.03" Flat SS
1	MAR-014	Camera Part Tilt Drive Gear (Pro 4)

Steps

Unscrew the two 4-40 X 1-4 inch Phillips head screws that hold the camera tilt servo motor into the camera mount base. Make sure to keep track of the washers.
Pull the camera tilt servo motor from the camera mount base.
Unsolder the camera tilt servo wires from the camera interface board.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tips

Some camera tilt servo motors have shims underneath of the servo to align the gears. If your camera tilt servo motor has shims, make sure to keep track of the shims and replace them when replacing the motor.

[ Help us improve this document ]