Camera Tilt Servo Motor Assembly Replacement Procedures

Time required for this step: Approximately 5 Minutes

Tools required for this step:

• #1 Phillips Head Screw Driver

Parts involved in this step:

MAR-012 Camera Tilt Servo Motor Assembly

Steps

1. If necessary, solder the wires from the camera tilt servo motor to the camera interface board.

2. Orient the camera tilt servo motor at the back of the camera mount base with the gear over the tilt shaft. The tilt servo motor wire should also be aligned with the notch in frame for the tilt servo motor.

3. Place the camera tilt servo motor in the back of the camera mount base.

4. Replace the two 4-40 X 1-14 inch camera tilt servo motor screws with washers. The washers are used to retain the tilt servo motor. Keep the washers toward the camera tilt servo while tightening the screws.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view

Tip

Some camera tilt servo motors have shims underneath of the servo to align the gears. If your camera tilt servo motor has shims, make sure to replace them when replacing the motor.