Desiccant Pack Removal Overview

Skill level recommended: Intermediate

Total time required: Approximately 31 Minutes

Tools required:

• #2 Phillips Head Screw Driver
• 7/16 Inch Open End or Socket Wrench
• 5/16 Inch Open End Wrench or Nut Driver
• 5/16 Inch Open End Wrench or Nut Driver (Additional)
• Wooden Dowel Rod 3/8" x 12"
• Dental Pick or equivalent

The following components must be removed:

• Float Block Kit
• Skid Kit
• Horizontal Thruster Propeller Kit (Left and Right)
• Horizontal Thruster Nozzle Kit
• Dome Retaining Rings and Main Hull Rods
• Rear Dome
• Light Dome
• LED Light Module Assembly
• Desiccant Pack

Notes:

• There are three desiccant packs. One is located in the rear of the main hull and the other two are located in each of the LED Light Modules.