Desiccant Pack Replacement Overview

Skill level recommended: Intermediate

Total time required: Approximately 33 Minutes

Tools required:

• O-Ring Lubricator
• 5/16 Inch Open End Wrench or Nut Driver
• 5/16 Inch Open End Wrench or Nut Driver (Additional)
• Torque Wrench
• Red Loctite or equivalent
• 7/16 Inch Open End or Socket Wrench
• #2 Phillips Head Screw Driver

The following components must be replaced:

• Desiccant Pack
• LED Light Module Assembly
• Light Dome
• Rear Dome
• Dome Retaining Rings and Main Hull Rods
• Horizontal Thruster Nozzle Kit
• Horizontal Thruster Propeller Kit (Left and Right)
• Skid Kit
• Float Block Kit

Notes:

• There are three desiccant packs. One is located in the rear of the main hull and the other two are located in each of the LED Light Modules.