LED Light Printed Circuit Board Removal Procedures

Time required for this step: Approximately 5 Minutes (10 Minutes for both sides)

Tools required for this step:

• #1 Phillips Head Screw Driver
• Soldering Iron

Parts involved in this step:

VR-PRO4-05-0002 LED Light Printed Circuit Board

Steps

Note: The following step-by-step instructions apply to one side. Repeat these steps on both sides if you plan to remove both LED Light Boards.

1. Unsolder the two wire leads from the face of the LED light board.

2. Remove the wires by pulling them from the rear of the LED light module assembly.

3. Unscrew the two 2-56 X 1/4 inch Phillips head screws the hold the LED light board to the LED light mount.

4. Remove the LED light board from the LED light mount.

If the video above doesn't play in your browser, click this play icon to try an alternate method: , or click this manual reference icon to view an exploded view