Comprehensive Parts List for:

Main Hull Tube

The following list is provided to identify all of the parts that will be involved in the process of removing and replacing the Main Hull Tube. Replacing these parts with new parts is not required unless it is determined that a part is not suitable for reuse. VideoRay recommends that new O-rings be used whenever possible.

FB-001-KIT-P4 Float Block Kit

SK-PRO4-KIT Skid Kit

GTO-006LS-KIT Vertical Thruster Propeller Kit

FB-008 Vertical Thruster Splitter

CS-KIT-BL(v) Vertical Thruster Cartridge Seal

THR-HARNESS-P4-KIT Strain Relief Cable Kit

LT-001-4 Light Dome

VR-PRO4-05-0001 LED Light Module Assembly

GTO-006L-KIT~GTO-006R-KIT Horizontal Thruster Propeller Kit (Left and Right)

VR-PRO4-08-0001 Horizontal Thruster Nozzle Kit

MHU-002-GY-KIT Dome Retaining Rings and Main Hull Rods

MHU-004(f) Front Dome

VR-PRO4-13-0001-N Front Hull Ring Assembly with Camera

MHU-004(r) Rear Dome

MHU-003-GY-KIT Rear Hull Ring Assembly

TLK-005-300-CN Desiccant Pack

CB-01-PRO4-SET ROV Board Set

HF12U-10-ND Camera Ribbon Cable

TB9P-KIT-P4 Termination Block and Accessory Port

VR-PRO4-15-0001 Pressure Sensor Kit

VR-PRO4-02-KIT Vertical Thruster Kit

VTH-0054 ROV Wire Harness

HT-001-GY Horizontal Thruster Tube

MHU-001-4 Main Hull Tube

This list includes quantities for both sides where applicable. With the exception of the horizontal thruster propellers, parts can be interchanged between left (port) and right (starboard) sides.